1. Clean and dry surface thoroughly with glass cleaner.

2. Measure decal with window using level or tape measure.

3. Make marks on the transfer tape and also the glass.

4. Lay decal face down and remove paper backing from transfer tape allowing design to adhere to transfer tape.

5. Place taped off design in the desired location according to your measurements and lightly tack it to surface.

6. Using a credit card, start at center of design
and begin to squeegee transfer tape to surface vertically.

7. Apply at 60 degrees or higher (use hair dryer or turn on heater if needed).

8. Remove transfer tape by pulling it off at a 90 degree angle.

7. Enjoy!